Filter
Top Products
32
206-4261
Custom Master TV Setup (Cont.)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the values for these
Installer Menu items.
Custom Master TV Setup Procedure
1. Turn ON the TV.
If the Express Script Installer Menu Wizard appears on the screen
when you turn ON the TV, exit the wizard.
2. Set Installer Menu items.
This step provides specic instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 21 to 30 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 21 for further information).
The next step depends on whether the Express Script Installer
Menu Wizard appeared when you turned ON the TV:
• If the wizard did appear, the TV is in a factory default state, and
you can proceed to set Installer Menu items. Go to step (c).
• If the wizard did not appear, go to step (b).
b) Set Installer Menu item 117 FACT DEFAULT to 1 and press OK on
the Installer Remote.
This clears all Installer Menu custom settings, channel lineup, etc. and
restores the factory default settings. The value will change back to 0
after the PTC has been restored to factory default condition. This step
ensures that the TV Channel Memory will be the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0. • HRC: Set to 2.
• CATV: Set to 1 (default). • IRC: Set to 3.
d) Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to
select the speaker conguration.
e) Set any other Installer Menu items that affect your TV programming
network to the required conguration. For example, enable/disable
Aux inputs, set a Start Channel, etc.
If you intend to use a TLX le for cloning purposes, you may also
congure Pro:Centric settings in the IP Environment Menu
(accessible from the Installer Menu). See “IP Environment Setup”
on pages 57 to 60 for further information. However, note that you
cannot return directly to the Installer Menu from the IP Environment
Menu; thus, you may wish to set all Installer Menu items as needed
before you access the IP Environment Menu. Otherwise, you will
need to reaccess the Installer Menu to set additional items.
f) After you have adjusted all Installer Menu item settings as required,
press OK once on the Installer Remote to save your changes; then,
press OK again to exit the menu.
(Continued on next page)
117 FACT DEFAULT 000
003 BAND/AFC 001
027 HOSPITAL MODE 254
xxLY560M PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.020 CPU V3.11.00
Note: If an Aux input will not be used,
it is advisable to disable it. After the TV
setup is transferred to the PTC (see
step 5), the only way to remove Aux
inputs from the channel lineup, is to go
to the Channel Preview/Banks Setup
Menu and select Normal-Deleted.