Filter
Top Products
33
206-4261
4. (PTC cloning only / Optional) Run Auto Tuning.
Note: If you run Auto Tuning with the intention to clone the resulting
channel lineup and the Target TV(s) is/are to remain in Pass-through
Mode, you MUST use a TLL le for this cloning purpose.
a) Use the Installer Remote to access the Channel Menu. Then, select
Auto Tuning and follow the on-screen instructions to search for all
available analog and digital channels.
b) Use the Channel Edit option in the Channel Menu to edit the channel
lineup, as necessary. Add/delete channels per your system requirements.
c) Use the Channel Label option in the Channel Menu to select the
appropriate trademark/icon for each channel’s Channel-Time on-screen
display. Icons are available for familiar channels, such as ABC, CBS,
NBC, etc. Identiable labels (icons) should enable the end user to readily
know what common networks are available.
Note: If Installer Menu item 103 ATSC TUNE MODE is set for Physical
Channel tuning (default and recommended setting), channels with minor
channel numbers higher than 255 will not transfer correctly in step 5. If item
103 is set for Virtual Channel tuning and either the major or minor channel
numbers are higher than 255, the channel(s) will not transfer correctly in
step 5.
Note: You can add the channel icons in this step or as described in step 6.
Also in step 6, you can add custom text labels for channels without icons.
Use the TV setup menus to set the TV
features to the desired configuration
for the end user.
PICTURE
AUDIO
INPUT
OPTION
TIME
MY MEDIA
CHANNEL
LOCK
Audio Menu Note: Audio Menu options
are inaccessible (grayed out) if TV Speaker
is not selected (i.e., Pillow Only is selected).
(Continued from previous page)
3. Set up TV features.
On-screen setup menus control the features of the TV. Press MENU
on the Installer Remote to access the TV setup menus, and then set
Channel, Picture, Audio, etc. options to the desired configurations. See
“Clonable TV Setup Menu Features” list page 31 and also notes below.
Note: If you intend to use a TLX le for cloning purposes, and you
wish to use the TV Zoning feature, make sure to assign the appropriate
TV Zone # at this time as described in Reference section, “Using the
TV Zoning Feature.”
Note: If you intend to clone the PTC, remember that only one TV
source’s clonable setup menu settings will be cloned. Thus, the TV
setup menu settings should be applicable to the analog or digital
channel or Aux input to which the Target TV will be set during Teaching.
Note: If desired and if appropriate, depending on the cloning method
to be used (see “Cloning Methods” on page 31), you can run Auto
Tuning (see step 4) prior to completing this step.
Custom Master TV Setup (Cont.)
Use Channel Menu options to
run Auto Tuning, edit channels,
and select channel icons.
CHANNEL
OK
Move
• Auto Tuning
• Manual Tuning
• Channel Edit
• Channel Label
(Continued on next page)
Note: The next three steps (4 to 6) are applicable for PTC cloning only (i.e., cloning
using a TLL le). If you intend to use a TLX le for cloning purposes, proceed directly
to step 7 to verify the TV setup.