Filter
Top Products
System settings Windows CE
38 M000174-19
4.13 BOOTDEVICE SETUP (BOOTDEVICE)
Note:
The BootDevice setup is only available on XV100 devices.
BootDevice Setup is used to specify the medium from which the panel is to start. The relevant
selection options are displayed according to the features of the panel.
4.13.1 C
OMMAND LINE PARAMETERS
The following parameters are supported:
Parameter Description
-device <boot device type>
1: Start of InternalStorage
2: Start of StorageCard
3: Start of USBStorage
-state Displays the current status
-r Restarts the panel after the settings are made. This option only functions
if a setting was changed.
4.13.2 F
IRMWARE OS
The internal firmware OS is started if the CTRL/DOWNLOAD button is held down for approx. 3
seconds while the device is powered up. Only the most important functions can therefore be run in
order to make the device operational again.
4.13.3 U
PDATE OF THE OPERATING SYSTEM
In order to install a new operating system on the device, the appropriate BIN file must be copied to the
folder \<BootDeviceName>\OS\. When the panel is restarted, the BIN file is detected and
automatically installed.