Filter
Top Products
Windows CE ActiveSync connection
M000174-19 43
6.2 PROCEDURE: ACTIVESYNC
The Microsoft ActiveSync must be started on the PC.
The «RepllogSwitch.exe» program must be started on the MICRO PANEL («Start – Programs –
Communication – RepllogSwitch»)
Connect the panel and the PC via USB or the serial interface.
Select the required interface in the dialog shown above.
The following dialog will then appear. If the dialog closes again without any error messages, this
means that the connection could be established successfully.
The following dialog is displayed on the PC (only a chapter of the dialog is shown)**:
Confirm the dialog with «No»
The connection was successful.