Filter
Top Products
ActiveSync connection Windows CE
42 M000174-19
6 ACTIVESYNC CONNECTION
An ActiveSync connection can be used for data transmissions, diagnostics or debugging. An
exclusively DEBUG connection can also be created via «Manual Server» (see also
Procedure:
Manual Server). The ActiveSync connection requires the installation of the Microsoft ActiveSync
program on the PC and the starting of the «Repllogswitch» program on the device. This connection
can be implemented via the serial or USB interfaces. Depending on the MICRO PANEL, the
installation of the «WceUsbSh.sys» driver is required on the PC for the USB connection. The driver
files are contained in the GALILEO installation but are not automatically installed.
Note:
The connection requires at least ActiveSync Version 3.5. ActiveSync is a program from Microsoft and
can be obtained free of charge from the Internet.
USB driver installation:
1. Connect devices with each other.
2. Select the .....WcUsbSh.inf file in the «New Hardware Found» dialog. The driver is located in the
subdirectory «Tools\USB Driver» in the GALILEO installation directory.
6.1 REPLLOGSWITCH
The «Repllogswitch.exe» program is used for establishing a connection with a PC via «ActiveSync» or
«Manual Server». This is described in the chapter
Procedure: ActiveSync or Procedure: Manual
Server.
The program supports the call with the following command line parameters:
Parameter Description
-s
The ActiveSync connection is started directly via the serial connection
without the display of the above dialog.
-u
The ActiveSync connection is started directly via the USB connection
without the display of the above dialog.
-e
The DEBUG connection is started directly via the Manual Server without
the display of the above dialog. See also the chapter
Procedure: Manual
Server.
-a «IP address:port» IP address and port number of the host PC for connection establishment
using «Manual Server». This entry is absolutely necessary when using
«Manual Server». See also the chapter
Procedure: Manual Server.
Note:
The buttons «..USB..» and «..serial..» are only operable if the MICRO PANEL has the interface
concerned and this is still available.