Filter
Top Products
Troubleshooting
Common
Symptom Cause Action (See)
Power doesnt turn on.
The unit doesnt operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that allconnections are
correct.
The fuse is blown. Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure toinstall the
correct fuse with thesame rating.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
PressRESET. (Page 10)
Operation with the remote con-
trol isnt possible.
The unit does notoperate cor-
rectly even when theappropriate
remote control buttons are
pressed.
The remote control operation mode
is incorrect.
Switch to the correct remote control mode.
(Page 15)
The remote control codeis incor-
rect.
Make sure the remote controlselection
switch setting and codetype setting are the
same. (Page 57, Page 59)
Battery power is low. Load new battery.(Page 11)
Some operations are prohibited
with certain discs.
Check by using another disc.
Playback is not possible. Thedisc is dirty. Clean disc. (Page 68)
The loaded disc isa type this unit
cannot play.
Check what type thedisc is.
Non compatible video system disc
is loaded.
Change to a disccompatible to your video
system.
No sounds are heard.
The volume level willnot rise.
Cables are not connected correctly. Connect the cables correctly.
With some discs, 96kHz output is
prohibited.
Switch the output setting to48 kHz. (Page 56)
The unit isperforming still, slow mo-
tion or frame-by-frame playback.
There is no soundduring still, slow motion or
frame-by-frame playback.
There is no picture. The parking brake cord isnot con-
nected.
Connect a parking brake cord,and apply the
parking brake.
The parking brake is notapplied. Connect a parking brake cord,and apply the
parking brake.
The icon
is displayed, and op-
eration is not possible.
The operation is prohibited for the
disc.
This operation is notpossible.
The operation is notcompatible
with the discs organization.
This operation is notpossible.
The picture stops (pauses) and
the unit cannot beoperated.
Reading of datahas become impos-
sible during playback.
After pressing g once, startplayback once
more.
There is no sound.
Volume level islow.
The volume level islow. Adjust the volume level.
The attenuator is on. Turn the attenuator off.
There is audio andvideo skip-
ping.
The unit is notfirmly secured. Secure the unit firmly.
Additional Information
En
65
Appendix
Additional Information