Filter
Top Products
3 Turn MULTI-CONTROL to select the
function.
BSM (best stations memory)—REGION (regio-
nal)—LOCAL (local seek tuning)—TA (traffic
announcement standby)—AF (alternative fre-
quencies search)
Notes
! You can also select the function by pressing
FUNCTION on the remote control.
! Toreturn to theprevious display, press
DISP/BACK/SCRL.
! Toreturn to themain menu, press and hold
DISP/BACK/SCRL.
! Toreturn to theordinary display, press
BAND/ESC.
! If you do not operate functions within about
30 seconds, the display automatically returns
to the ordinar y display.
! If MW/LW band is selected, you can only se-
lect BSM or LOCAL.
Storing the strongest broadcast
frequencies
BSM (best stations memory) lets you automa-
tically store the six strongest broadcast fre-
quencies.
! Storing broadcast frequencies with BSM
may replace broadcast frequencies you
have saved using buttons 1/S.Rtrv to 6/
.
1 Use MULTI-CONTROL to select BSM in
the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Press MULTI-CONTROL to turn BSM on.
The six strongest broadcast frequencies are
stored in the order of their signal strength.
# Tocancel, press MULTI-CONTROL again.
Tuning in strong signals
Local seek tuning lets you tune in only those
radio stations with sufficiently strong signals
for good reception.
1 Use MULTI-CONTROL to select LOCAL in
the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Press MULTI-CONTROL to display the
setting mode.
3 Turn MULTI-CONTROL to set the sensi-
tivity.
FM: OFF—LEVEL1—LEVEL2—LEVEL3—
LEVEL4
MW/LW: OFF—LEVEL1—LEVEL2
The LEVEL4 setting allows reception of only
the strongest stations, while lower settings let
you receive progressively weaker stations.
# You can also perform the same operations by
pressing a or b.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Selecting alternative frequencies
When the tuner cannot get a good reception,
the unit automatically searches for a different
station in the same network.
% Press and hold TA/AF to turn AF on.
# Toturn off, press MULTI-CONTROLagain.
Notes
! You can also turn this function on or off in the
menu that appears by using
MULTI-CONTROL.
! Only RDS stations are tuned in during seek
tuning or BSM when AF is on.
! When you recall a preset station, the tuner
may update the preset station with a new fre-
quency from the station’s AF list. (This is only
available when using presets on the FM1 or
FM2 bands.) No preset number appears on
the display if the RDS data for the station re-
ceived differs from that for the originally
stored station.
Operating this unit
En
17
Section
02
Operating this unit