Filter
Top Products
Using the Dolby Pro Logic II
Dolby Pro Logic II creates five full-bandwidth
output channels from two-channel sources to
achieve high-purity matrix surround.
! If both the center and the rear speakers are
set to OFF, you cannot use this function.
! Dolby Pro Logic II supports up to 48 kHz
sampling rate stereo source and has no ef-
fect on other types of source.
1 Use MULTI-CONTROL to select PLII in
the audio function menu.
Refer to Introduction of DSP adjustments on
page 52.
2 Press c or d to select the desired
mode.
! MOVIE – The Movie mode suitable for
movie playback
! MUSIC – The Music mode suitable for
music playback
! MATRIX – The Matrix mode for when FM
radio reception is weak
! OFF – Turn Dolby Pro Logic II off
# You can adjust the music mode only when
MUSIC has been selected.
Adjusting the Music mode
You can adjust the Music mode with the fol-
lowing three controls.
! Panorama (PANO) extends the front stereo
image to include the surround speakers for
an exciting “wraparound” effect.
! Dimension (DIME) allows you to gradually
adjust the sound field either towards the
front or the rear.
! Center Width Control (CENTER) allows cen-
ter-channel sounds to be positioned be-
tween the center speaker and the left/right
speakers. It improves the left-center-right
stage presentation for both the driver and
the front passenger.
1 Use MULTI-CONTROL to select PANO
(adjusting music mode) in the audio func-
tion menu.
Refer to Introduction of DSP adjustments on
page 52.
# You can adjust the music mode only when
MUSIC has been selected.
2 Press c or d to select controls.
PANO (panorama)—DIME (dimension)—
CENTER (center width)
3 Press d to select PANO and then press
a to turn the panorama control on.
# To turn the panorama control off, press b.
4 Press d to select DIME and then a or b
to adjust front/rear speaker balance.
+3 to –3 is displayed as the front/rear speaker
balance moves from front to surrounds.
5 Press d to select CENTER and then a or
b to adjust the center image.
Each time a or b is pressed it gradually
spreads the center channel sound into the
front left and right speakers over a range 0 to
7.
3 is the default and it’s recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Using the sound field control
The SFC function creates the sensation of a
live performance.
! The acoustics of different performance en-
vironments are not the same and depend
on the extent and contour of space through
which sound waves move and on how
sounds bounce off the stage, walls, floors
and ceilings. At a live performance you
hear music in three stages: direct sound,
early reflections, and late reflections, or re-
verberations. Those factors are programed
into the SFC circuitry to recreate the acous-
tics of various performance settings.
Available accessories
En
54
Section
03