Filter
Top Products
# You cannot select speakers whose size is set
to OFF. (Refer to Setting the speaker setting on
page 58.)
3 Press a or b to adjust the speaker out-
put level.
+10 to –10 is displayed as the level is in-
creased or decreased.
Note
To adjust the speaker output levels in thismode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Use MULTI-CONTROL to select
TEST TONE in the audio function menu.
Refer to Introduction of DSP adjustments on
page 52.
2 Press d to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L (front speaker left)—CENTER (center
speaker)—FRONT-R (front speaker right)—
REAR-R (rear speaker right)—REAR-L (rear
speaker left)—SUB.W (subwoofer)
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 tostop the test
tone.
# The settings do not appear forspeakers
whose size is set to OFF. (Refer to Setting the
speaker setting on page 58.)
3 Press a or b to adjust the speaker out-
put level.
+10 to –10 is displayed as the level is in-
creased or decreased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press c to stop the test tone output.
5 Press BAND/ESC to return to the ordin-
ary display.
Notes
! If needed, select speakers andadjust their ‘ab-
solute’ output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at FRONT-L (speaker output level).
Both provide the same results.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Use MULTI-CONTROL to select INITIAL
(time alignment mode) in the audio func-
tion menu.
Refer to Introduction of DSP adjustments on
page 52.
2 Press c or d to select the time align-
ment.
! INITIAL – Initial time alignment (factory set-
ting)
! AUTO TA – Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on
page 56.)
! CUSTOM – Adjusted time alignment that
you can create for yourself
! TA:OFF– Turn the time alignment off
# If auto TA and EQ have not been carried out,
SETA-TA is displayed insteadof AUTOTA.
Available accessories
En
60
Section
03