eyon
e
as cs
2.64
3.
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2
before
going on to step 4.
4.
Press
ENTER
. The display now shows either:
77:Fax Number
_
or
77:Fax Number
9-5558743
5.
Use the numeric keypad to enter the “hub” machine’s number
exactly
as
your machine should dial it, including whatever codes your phone system
may require. The number can be up to 40 characters in length:
77:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters
beyond those 20 (such as with an international long-distance numbers),
press
to scroll leftward or to scroll rightward.
Important: Do not press
ENTER
.
Note: If you make a mistake or want to erase characters entered in a
previous setting, press
CANCEL
to erase leftward. Or, if you want
to change just one character in the number, press
to move the
cursor leftward, or
to move it rightward, to that character and
press
CANCEL
to erase it. Then re-enter until the number is just as
you want it.
6.
Now,
while you still can see the fax number on the display
, press
COMMUNICATION OPTIONS
three times
and then press
ENTER
. The
display shows:
Relay Tx
Group No. _
7.
Use the numeric keypad to enter the two-digit identifier (0
1–32
) for the
first call group. You can specify up to 10 separate groups for each relay
broadcast initiation; between the entry of each new group, press
GROUP DIAL
to insert a comma
but
do not
insert a comma after the
last
group number. For example, here, we’ve entered
0
,
4
,
GROUP DIAL
,
1
,
1
,
GROUP DIAL
,
2
,
4
:
Relay Tx
Group No. 1,24_
Note: The display shows only four characters of the group number.
Important: Again, do not insert a comma after the last group number.
When the entry is complete, press
ENTER
.
8.
If you want the transmission to begin
immediately
every time you press the
key, press
ENTER
again and skip to step 11.
If you want to
delay
the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS
,
ENTER
.
9.
There’s a choice to make. Instruct your fax to carry out this delayed
command in
one
of the following ways:
Option 1: Perform the command
once
at a certain time on a certain
day of the month (For example, “Do this at 5:05
PM
on
the 30th.”)
To select this option, use the numeric keypad to enter the
date and time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time
each day you press
the key
. (For example, “Do this at 5:05
PM
today.”)
To select this option, use the numeric keypad to enter
0
,
0
(
i. e., 00
), and then the time when the fax could perform
the command:
Delayed
Enter Time: 00/17:05
10.
Press
ENTER
,
ENTER
.
11.
The display now shows the next programmable one-touch key.
If you
do not
wish to enter or change
any other
key’s programming, press
STOP
to return your machine to its usual standby mode.
If you
do
wish to enter or change this key’s programming, go back to step 3.
If you wish to enter or change
another
key’s programming, go back to step 2.
