Beyond the basics
2.
Setting the transmission confirmation stamp
You can set your fax machine so that it will automatically place a small
stamp
mark on
the front of each
original
document that it successfully scans.
Note:
This feature is available only for document through the document feeder.
Important:
Be sure that this feature is turned off if you are sending original
documents you don’t want the fax to stamp.
1.
If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY
/
FAX
to change to Fax mode.
2.
Press
PROGRAM
,
J
,
1
,
5,
ENTER
. The display shows your fax’s current stamp
setting:
Stamp: Off
Program/Enter
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
3.
To change the setting, press
PROGRAM
once or twice until your chosen setting
appears. In this example, we’ve chosen
On
.
Stamp: On
Program/Enter
4.
Press
ENTER
to save the setting.
Setting the language
While English is the language in which your machine initially is set to display messages
and print reports, you can set it to “speak” French or Spanish, too! As you give the order
for the machine to change languages, it “rolls” from English to French to Spanish and
then back to English.
To make the change from one language to the next, change to the Fax mode then press
PROGRAM
,
#
.
¿Qué es? — or, What is it?
If, after making a language change, you’re not sure which language is showing, press
PROGRAM
(do
not
press
ENTER
),
and decide based on what results on the display:
A Num. Une-Touche
Program./Val.
is French.
A Núm. Una-Tecla
Program./Sel.
is Spanish.
If the language you see is the one you want, press
STOP
to return to standby mode. If you
want to change the language, press
STOP
to return to standby mode and then press
PROGRAM
,
#
again to go to the next language in the cycle.
