Alpine IXA-W407 Car Stereo System User Manual


 
12-EN
Adjusting Bass/Treble
You can change the Bass/Treble frequency emphasis to
create your own tonal preference.
Touch [ ] to display the Bass/Treble adjusting screen.
Touch [ ] or [ ] on the scroll bar to scroll the setup items line
by line.
Adjustment cannot be performed when an external audio processor is
connected or Defeat is set to ON.
Setting the Bass level
You can emphasize or weaken the bass frequency.
Touch [ ] or [ ] of Bass Level to select the desired bass level.
Setting range: –7 to +7
Setting the Bass Center Frequency
The displayed bass frequency is emphasized.
Touch [ ] or [ ] of Bass Freq. to select the desired bass center
frequency.
Setting range: 60 Hz, 80 Hz, 100 Hz, 200 Hz
Setting the Bass Bandwidth
Changes the boosted bass bandwidth to wide or narrow.
A wider setting will boost a wide range of frequencies
above and below the center frequency. A narrower
setting will boost only frequencies near the center
frequency.
Touch [ ] or [ ] of Bass Bandwidth to select the desired bass
band width.
Setting range: Wide1 to Wide4
The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
Setting the Treble Level
You can emphasize the treble frequency.
Touch [ ] or [ ] of Treble Level to select the desired treble
level.
Setting range: –7 to +7
Setting the Treble Center Frequency
The displayed treble frequency is emphasized.
Touch [ ] or [ ] of Treble Freq. to select the desired treble
center frequency.
Setting range: 10 kHz, 12.5 kHz, 15 kHz, 17.5 kHz
The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
Setting the Loudness
Loudness introduces a special low- and high-frequency
emphasis at low listening levels. This compensates for
the ear’s decreased sensitivity to bass and treble sound.
Touch [ ] or [ ] of Loudness to set to ON or OFF.
Multi Information Function
The Multi-Information display, allows the user to add up to 4 user
selectable functions. These can be for viewing or operating from a
single screen. See
“MultiInfo Setup” on page 22 for itme selections.
1
Press SOURCE to activate mode switching
screen.
2
Slide the display horizontally with your finger or
press
/ to select Multi Info mode, and then
touch the Multi Info mode window displayed in the
center of the screen.
The Multi Information main screen is displayed.
Display example for Multi Information mode main screen
The selected 4 items are displayed as small screens. If no item is
selected, the default items will be displayed.
3
Touch the desired item to perform further operation.
Depending on the selected items, full screen or half screen may be
set, and in other cases, the screen size remains the same.
The unit is equipped with a World Clock function. The local time of 4
major cities in the world can be displayed according to the time set on
this unit. To use this function, please set the time of this unit (local time)
and time zone of your district first. Refer to
“Setting the Time” and
“Setting the Time Zone” on page 18.
Display example for World Clock screen of Multi Information
mode
Time and Time Zone set on this unit.
Time of 4 other cities (“00:00” is displayed before
setting).
Returns to Multi Info main screen.
World Clock Display