Filter
Top Products
29-EN
Adjusting the Level
Touch [ ] or [ ] of the desired frequency to adjust the level.
• When the speaker is set to the “OFF” mode, the graphic equalizer
for that speaker cannot be set. Refer to
“Setting the Speakers”
(page 29).
• Check the playable frequency ranges of the connected speakers
before making the equalizer adjustments. If the speaker’s playable
frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz
or 20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
• When Graphic EQ is adjusted, the adjustment for Parametric EQ
becomes ineffective.
The frequency bands of the graphic equalizer are fixed. This makes it
very difficult to correct for undesired peaks and dips at specific
frequencies. The parametric equalizer’s center frequency can be tuned
to these specific frequencies. Then, the bandwidth (Q) and level are
fine-tuned, independently, to make the necessary corrections. The
parametric equalizer function is an advanced tool for serious
audiophiles.
Setting item: P-EQ
1
Select L+R or L/R by touching [ ] or [ ] of P-EQ.
When Graphic EQ is adjusted, this setting will be turned off.
2
Touch [ ] of P-EQ.
The P-EQ list screen appears.
3
Touch [ ] of the desired speaker (channel).
The P-EQ adjustment screen appears.
4
Adjust the P-EQ to your preference.
Selecting the Band
Touch [ ] or [ ] of BAND to select the desired band.
Adjusting the Frequency
Touch [ ] or [ ] of Freq. to adjust the frequency of the
selected band.
Adjusting the Level
Touch [ ] or [ ] of Level to adjust the level of the selected
band.
Setting the Bandwidth
Touch [ ] or [ ] of Q to select the Bandwidth.
• When the speaker is set to the “OFF” mode, the parametric
equalizer for that speaker cannot be set. Refer to
“Setting the
Speakers” (page 29).
• It is not possible to adjust the frequencies of adjacent bands within 8
steps.
• Check the playable frequency ranges of the connected speakers
before making the equalizer adjustments. If the speaker’s playable
frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz
or 20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
• When the Parametric EQ is adjusted, the adjustment for Graphic EQ
becomes ineffective.
Setting item: Speaker Select
Set the connected speaker by touching the respective
[
] or [ ] button.
• Set the speaker which is not connected to OFF.
• Settings above can be carried out even when the speaker is set to
OFF in
“Speaker Setup” (page 30).
• To use the subwoofer in MONO with PXA-H700 or PXA-H701
connected, connect the subwoofer to the subwoofer output terminal
of PXA-H700 or PXA-H701.
Parametric Equalizer Adjustments
L+R: Sets the same adjustment values for the left and right
channels.
L/R: Different adjustment values can be set for the left and
right channels.
Setting the Speakers
Front1: OFF/FULL (Full Range)/TW (Tweeter)
Front2: OFF/ON
Rear: OFF/ON
Center: OFF/ON
SubW.: OFF/MONO/STEREO