Filter
Top Products
45-EN
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of this unit (AUX mode), follow the procedure described below.
1
Press
SOURCE to activate mode switching
screen.
2
Slide the display horizontally with your fignger to
select Audio/Visual mode.
Each time you slide the display, the mode switches
circularly in the following order :
Audio/Visual Navigation Camera Telephone
Multi Info Audio/Visual
3
Slide the display vertically with your finger, or press
SOURCE repeatedly to select AUX* source.
* The name which is given as the source name in “Setting the AUX
Mode” on page 20 is displayed.
4
Touch the AUX source window displayed in the
center of the screen.
The AUX source is activated and the display changes to the
external input screen.
• If the AUX source is not displayed on the main menu, set AUX IN to
ON by following
“Setting the AUX Mode” (page 20).
• The display mode changes by touching [WIDE].
For operation, refer to “Switching Display Modes” on page 14.
• After connecting the KCA-410C, its AUX input can be used only in
INTERRUPT MODE. For details, refer to the KCA-410C Owner’s
Manual.
Auxiliary Device
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the iXA-W407 correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the iXA-W407 is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the AUX mode operation has been
released. Engaging the parking brake can reactivate the AUX
mode, as long as the car’s ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To activate your auxiliary devices.”
Each time the ignition is turned OFF, perform the procedure of “To
activate your auxiliary devices.”
•
If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.