Filter
Top Products
16-EN
01GB06PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
From a PC
When you connect an external input source, you can name it with a
suitable name (Initial setting: “Auxiliary”).
1
Click [ ] for each AUX and select and click the
external input product name from the pull-down
menu.
Setting item: AUX Name
Setting contents: Auxiliary/TV/EXT.DVD/Portable/Game
• This item becomes possible to set only when AUX IN setting is on.
Setting/Adjusting the Navigation
Guidance Volume (Navi Mix)
If a navigation system is connected, its voice guidance will be mixed
with the system and output from the front speakers (Initial setting:
“OFF”). You can adjust the navigation guidance volume (Initial setting:
“0 dB”).
1
Click [ON] or [OFF] for “Navi Mix” in the main menu.
If you click [ON], select the setting value.
2
Click [ ] or [ ] to adjust the volume.
Setting contents: -10 to +10 dB
• For details on the connection of a navigation system, refer to the
installation manual.
Before Performing Automatic
Measurement
This unit is equipped with ImprintEQ, RoadEQ, and AutoTCR
automatic measurement functions.
Be sure to read before performing automatic
measurement.
• The automatic measurement should be performed in a quiet place
with the engine, air-conditioner, and heater turned off. If a mobile
phone or car phone is installed in the vehicle, move them outside of
the cabin, or turn the power off. Sound other than the measuring
sound (ambient noise around the vehicle, engine noise, and
ringtones) may interfere with measurement, resulting in inaccurate
measurement of the acoustic characteristics of the cabin.
• Be aware that the battery may be drained if you use the unit for an
extended period of time without running the engine.
• The microphone supplied with this product is specifically designed
for this type of measurement. Use of any other microphone will give
poor or no results. Use of microphones other than the one supplied is
not recommended.
• If the system is equipped with a power amplifier with input level
control or a powered subwoofer, the measurement may not be
possible if the input level is set low. However, to perform correct
measurement, the input level should not be set too high.
• For a power amplifier with low-pass filter, turn off the low-pass filter
of the power amplifier to make measurement. The low-pass filter in
the powered subwoofer or the power amplifier for a subwoofer
should be set at the highest cutoff frequency.
Measurement sequence for the automatic measurement
functions
Perform the automatic measurement in the following sequence.
When ImprintEQ is used:
First, ImprintEQ, then RoadEQ.
When ImprintEQ is not used:
First, Auto TCR, then RoadEQ.
• When ImprintEQ is used, AutoTCR is not required.
• When ImprintEQ and AutoTCR are performed after RoadEQ, re-
perform RoadEQ.
Naming the AUX Input (AUX Name)
Automatic
Measurement
Function
WARNING
• Do not perform automatic measurement while the vehicle is
running.
Automatic measurement requires microphones to be installed
in the cabin to measure acoustic characteristics, and the
speakers may output loud noise for measurement. This may
interfere with safe driving and lead to an accident.
01GB00PXAH800.book Page 16 Tuesday, February 8, 2011 9:04 PM