Filter
Top Products
17-EN
01GB06PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
From a PC
Setting ImprintEQ
ImprintEQ is a system to obtain the optimum acoustic effect from each
seat position, based on the automatically measured acoustic data of the
cabin.
To use ImprintEQ, you should perform acoustic measurement of the
cabin beforehand.
ImprintEQ measurement flow
1
Preparing for measurement.
• Park the vehicle in a quiet location.
• Close doors, windows, sunroof, etc.
• Turn the air-conditioner and heater OFF.
• Turn off the engine of the vehicle.
2
Preparing the microphone.
Place the microphone at ear level (a camera tripod is useful
for this purpose).
• The direction of the microphone does not affect the measurement.
3
Turn the ignition switch of the vehicle to ACC (On).
• If an air-conditioner or heater is turned on, turn it off. Measurement
should not be performed if air-conditioner or heater noise is present.
4
Click [ImprintEQ] for [Shortcut] tab in the main
menu.
The Automatic Measurement tab screen will be displayed.
• When you click [Automatic Measurement] in the Function switching
tab, the Automatic Measurement tab screen will also be displayed.
Refer to “Operating the Function Switching Tab” (page 7).
5
Click [Setup] for “ImprintEQ.”
The ImprintEQ mode selection screen will be displayed.
6
Select either [Factory Audio] or [Other] and click.
Factory Audio: When an automobile factory system is
connected to AUX1, choose this.
Other: Choose [Other] when a head unit other than
an automobile factory system (commercially
available unit including ALPINE products) is
connected.
If you select [Factory Audio], go to Step 7.
If you select [Other], go to Step 10.
7
Insert the SETUP DISC into the head unit. Click
[START] within 10 seconds of Track01 starting.
8
Following the instructions on the screen, adjust the
input level of the device connected to AUX1. When
“OK” is displayed, click [OK].
9
Click [START] within 10 seconds of Track02 starting.
Measurement of the frequency characteristic will be started.
When measurement is completed, a confirmation message
will be displayed.
• If you want to stop measurement, click [CANCEL].
10
Click [OK] when a message appears.
The Area Selection screen is displayed.
11
Select the listening position. Select the area from
[ALL], [FRONT], [FRONT LEFT], [FRONT RIGHT], and
[REAR], and click [Next].
If [ALL] is selected, the system will measures the
characteristics from all seat positions.
The measurement screen will be displayed.
Prepare the vehicle and install the microphone.
Turn the ignition key to ACC ON position, and start ALPINE
PXA-H800 Sound.
Select the listening position.
Following the instructions on the screen, conduct the
automatic measurement.
Select the target curve.
Save the measurement values.
When it is an automobile
factory system
Play back the SETUP DISC that comes
with the unit on the head unit.
For a system
other than an
automobile
factory system
01GB00PXAH800.book Page 17 Tuesday, February 8, 2011 9:04 PM