Filter
Top Products
58-EN
01GB07PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
From the Commander
Setting the Color for the Commander
Illumination Button (ILLUMINATION)
You can change the lighting color of the buttons. (Initial setting:
“BLUE”)
1
Press [FUNC.].
2
Rotate the [Rotary encoder] to select “Display
Setup,” and then press the [Rotary encoder].
3
Rotate the [Rotary encoder] to select
“ILLUMINATION,” and then press the [Rotary
encoder].
4
Rotate the [Rotary encoder] to select “BLUE” or
“RED.”
5
When the setting is complete, press and hold [ ]
for at least 2 seconds.
• If [ ] is pressed during setting, the unit returns to the previous
item.
Adjusting the Brightness of the Display
(Dimmer)
Set the Dimmer control to “Auto” to decrease the illumination
brightness of the unit with the head lights of the vehicle ON. This mode
is useful if you feel the unit’s backlighting is too bright at night. (Initial
setting: “Auto”)
1
Press [FUNC.].
2
Rotate the [Rotary encoder] to select “Display
Setup,” and then press the [Rotary encoder].
3
Rotate the [Rotary encoder] to select “Dimmer,” and
then press the [Rotary encoder].
4
Rotate the [Rotary encoder] to select “Auto” or
“Manual.”
5
When the setting is complete, press and hold [ ]
for at least 2 seconds.
• If [ ] is pressed during setting, the unit returns to the previous
item.
• When “Manual” is selected, the brightness of the display does not
change if you turn on the headlamps. This always sets the brightness
at the level specified in “Adjusting the Brightness Level of the
Display (Dimmer Level)” (page 58).
Adjusting the Brightness Level of the
Display (Dimmer Level)
With the Dimmer control ON, three Dimmer levels are available. The
highest, Level 3, being the most dim with the vehicle's headlights ON.
(Initial setting: “Level 1”)
1
Press [FUNC.].
2
Rotate the [Rotary encoder] to select “Display
Setup,” and then press the [Rotary encoder].
3
Rotate the [Rotary encoder] to select “Dimmer
Level,” and then press the [Rotary encoder].
4
Select one from “Level 1” through “Level 3” by
rotating the [Rotary encoder].
5
When the setting is complete, press and hold [ ]
for at least 2 seconds.
• If [ ] is pressed during setting, the unit returns to the previous
item.
01GB00PXAH800.book Page 58 Tuesday, February 8, 2011 9:04 PM