Dynex 40" LED TV
17
DX-40D510NA15
www.dynexproducts.com
Coaxial (good)
1 Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE jack on the side of your TV and to the antenna or cable TV wall
jack.
4 Plug your TV’s power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press
or
to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 55.
Notes
• Use a coaxial cable to eliminate interference and noise from
radio waves.
• Do not bundle the coaxial cable with the power cord or other
cables.
Cable or
satellite box
Coaxial cable
Side of TV
Coaxial cable
connector
ANT/CABLE
jack
On your TV