Filter
Top Products
18
Dynex 40" LED TVDX-40D510NA15
www.dynexproducts.com
Connecting an antenna or cable TV (no box)
1 Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE jack on the side of your TV and to the antenna or cable TV wall
jack.
3 Plug your TV’s power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
or
to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See “Automatically scanning for channels” on page 55.
Notes
• Use a coaxial cable to eliminate interference and noise from
radio waves.
• Do not bundle the coaxial cable with the power cord or other
cables.
• If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be
distorted. Adjust the antenna or use a highly directional
outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on
others, the problem may be caused by a poor or weak signal
from the broadcaster or cable TV provider.
• If you connect to cable or satellite TV without a set-top box and
experience poor picture quality, you may need to install a
set-top box to improve signal reception and picture quality.
Contact your cable or satellite TV provider about upgrading to
a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture displayed on your
TV is still displayed as SD, thus the picture quality will not be as
clear or crisp as it would be if the content was originally
recorded in HD.
Coaxial cable
Antenna or cable TV
(no box)
Side of TV
Coaxial cable
connector
ANT/CABLE
jack
On your TV