Filter
Top Products
ķ
25
The MODE Menu
DISPLAY – Display Brightness
You can adjust the display brightness with the
¢
<
/
>
but-
tons. When the limits of the control range are reached, the
display indicates for approx. 3 seconds "
MINIMUM
" and
"
MAXIMUM
" , respectively.
ACTIVE/INACTIVE Programme Position
At the factory, the receiver has been preprogrammed for all
satellite stations, including those with coded ("scrambled")
programmes.
It is possible to deactivate programme positions with the
¢
<
/
>
buttons. When in programme mode, inactive pro-
gramme positions will be skipped when they are selected
with the
]|
buttons on the remote control handset.
Inactive programme positions can be called up by entering
their number directly with the numeric buttons or with the
¢
<
/
>
buttons on the receiver.
With this menu option, inactive programme positions can be
reactivated in the same way.
Clearing the child lock
Call up the "CODE" menu function and enter your personal
code number (2537 in the above example). In this case, the
entry is visible. Press the
O
button and the child lock is
cleared.
The display indicates for approx. 3 seconds:
The receiver is unlocked and the security code cleared.
Remember your personal code number!
If you should forget your personal code number, the key É
on the last page (cover) will help you. With this combination
of button pressures, you will unlock the receiver and clear the
code number.
TIMER
opü+
I99 CODEXCLR
STEREO
SIGNAL IIIIIIIIIIIII
Datalink – Data Transmission
Datalink – Data Transmission
All memory data can be transmitted via the VCR socket
wQ
from a transmitting to a receiving Sat receiver.
Follow these steps:
Switch off both units and connect them with a phono (Cinch)
cable (sockets
wQ
).
Switch on the receiving unit.
On the transmitting unit, hold down the
¢
>
button and
switch on. Now, the unit sends the programme data to the
receiving unit. While transmitting, the display indicates
"
SEND
" (send data). If the receiving unit recognizes the
transmitted data, the display of the receiving unit changes the
programme number indication to "
RECEIVE
" (receive
data).
Transmission takes approx. 3 minutes. If transmission was
succesful, the display of both units will indicate "
I
" for pro-
gramme position 1.
If an error should occur during transmission, the message
"
ERROR
" appears in the display of the receiving unit. In this
case, data transmission must be repeated.