Filter
Top Products
ķ
29
Clearing a Timer position
It is possible to clear a programmed Timer position in the fol-
lowing way:
Press the
.
button to open the Timer menu.
Select the desired Timer position with the
xc
buttons.
(The above steps are not necessary if you are already in the
Timer menu and the desired Timer position is selected).
Press the
|
button.
The display indicates:
Now, if you press the
O
button, the selected Timer position
is cleared and the Timer menu is automatically exited.
If you press the
]
button instead, the Timer position will
not
be cleared and you can change the set values.
Indicating the Timer functions
During normal operation, the symbols of all programmed
Timer positions are illuminated in the receiver´s display.
When the Timer menu is active, the indication "TIMER" and
the symbol of the selected Timer are visible in the display.
During Timer operation, the symbols of the programmed
Timer positions are illuminated and the symbol of the active
Timer is flashing.
TIMER
opü +
I99 XCLEARXX
STEREO
SIGNAL IIIIIIIIIIIII
You can only store when in the stop time menu option.
If you exit the Timer menu by pressing the
.
button without
storing, the old setting is retained.
If the stop time lies before the start time, Timer operation will
be terminated only next day (for example, with 15.40 ... 13.20
hours. However, for recording a programme broadcast bet-
ween 23.40 and 0.40 hours, this entry makes sense and is
necessary).
Timer operation
As soon as the start time is reached, the corresponding pro-
gramme is switched on. The symbol for the active Timer is
flashing (e.g.
“
1
with Timer 1).
At the same time, a switching voltage is output on the EURO-
AV VCR socket. Correspondingly equipped video recorders
switch immediately to "AV recording".
When the stop time is reached, the receiver switches to
standby and the Timer concerned is automatically cleared.
The switching voltage on the EURO-AV VCR socket is
switched off. Correspondingly equipped video recorders
switch to "STOP".
During timer operation (flashing Timer symbol), it is not allo-
wed to make any adjustments on the recorder or by means of
the remote control handset. This would interfere with Timer
recording.
Remote control via a video recorder
If you possess a correspondingly equipped GRUNDIG video
recorder, the receiver can remotely be controlled in a very
convenient way via the recorder. In this case, preprogram-
ming of up to 8 Timer positions is possible.
The necessary remote control cable can be obtained as
GRUNDIG accessory.
The cable must be connected to the video recorder and to the
socket
q` (REM. CONTR. VCR) on the receiver (see "Rear of
Receiver"). Then, the receiver can be switched to standby.
When a programme is recorded, the indication "
VCR-REC
".
is flashing in the display of the receiver. During a video recor-
ding, it is not allowed to make any adjustments on the recei-
ver (or with the remote control handset of the receiver). This
would interfere with the recording.
Attention!
The entered Timer times must make a sense (start time
before stop time). They are not allowed to overlap each
other (start time of next Timer position before stop time of
preceding Timer position).
TIMER Menu