Filter
Top Products
Remote Control Functions
ķ
26
b
Standby
With the
b
button, the receiver is switched to standby. The
display indicates "Ǽ". LNC, switching- and AV voltages are
switched off.
When in standby, pressing one of the numeric buttons
0…9 switches on the corresponding programme. When
using the
]|
buttons, the receiver switches to the last
selected TV programme (Last Station Memory).
¢
TV
Button
When using a suited TV receiver, the
¢
TV
button allows you to
toggle between satellite and terrestrial reception.
.
Button
Pressing the
.
button opens the Timer menu (see chapter
"Timer Menu").
A further pressure on the
.
button closes the Timer menu.
O
Button
Pressing the
O
button indicates for approx. 3 seconds the
satellite position, e.g., "
10
°
EAST
".
In addition, this button is used for a variety of other functions
(e.g., storing the Timer programme in memory, see chapter
"Timer Menu").
Switching the Remote Control Level
So that you can independently control two SAT receivers
being operated at a time (e.g., one for TV reception and the
other for video recording), it is possible to switch the remote
control level.
When switching the receiver on while holding down the
¢
P/F button on the receiver, the current level "
REMOTE 1
"
respectively "
REMOTE 2
" is indicated for approx. 3
seconds. At the factory, level 1 (Remote 1) has been preset.
When holding down the
¢
P/F button a longer time when
switching on, the receiver will switch to the other level.
Through simultaneously pressing the
-
(
8
) button on the
remote control handset and one of its other command but-
tons, you can switch to the second command level of the
remote control so that you can control a second receiver
independently of the first one.
Direct Programme Selection
Use the numeric buttons 0…9 to directly select the desi-
red programme (position).
If you enter more than one digit within approx. 3 seconds,
you can call up 2- or 3-digit programme positions.
If no second or third entry is made within this time, the entry
cursor jumps to the units position.
You can select 199 programme positions for TV and radio
each.
Further functions of the numeric buttons are explained in
chapter "Buttons on the Remote Control Handset".
Radio/TV Switching
Use the 0or
¢
RADIO
button to switch between TV and radio
mode.
In radio mode, the picture screen remains dark and an “
R
“
appears after the station name in the display. When swit-
ching, the display indicates for approx. 2 seconds “
RADIO
“
or “
TV
“.
]| Programme Select Buttons
Step-by-step programme selection is effected with the
]|
buttons. Holding down these buttons automatically
selects the programme positions at high speed. Inactive pro-
gramme positions are skipped.
xc
Buttons
In the Timer menu (see chapter "Timer Menue"), you can
select one of the 4 Timer positions with the
xc
buttons.
After pressing the
¢
F
button, you can control the motor for
positioning the aerial by pressing the
xc
buttons.
If you press and hold down the
¢
TV
SAT
button, you can set the
volume of your TV set with the
xc
buttons.