Filter
Top Products
Advanced Settings
28
Setting Item Default Value Setting Details
No
terminals.
speaker terminals
speaker terminals
r
In the following cases, this item will be set to
"No":
– "Front Speakers Type" is set to "Bi-Amp".
– "Height 1 Speakers Type" is set to the one
other than "Not Use".
–
r
For impedance, check the indications on the back of the speakers or their instruction manual.
Speaker Configuration
Allows you to change the speaker configuration such as presence or not of each speaker,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup. Audio will not be output while you are making this setting.
Setting Item Default Value Setting Details
Subwoofer 2 ch Set the SW PRE OUT jacks which output audio
signals.
"1ch": Only the SW1 PRE OUT jacks output audio
signals.
"2ch": Both the SW1 PRE OUT jacks and the SW2
PRE OUT jacks output audio signals.
"No": Neither the SW1 PRE OUT jacks nor the SW2
PRE OUT jacks output audio signals.
Front 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
"Front" will be fixed to "Full Band" if "Subwoofer"
is set to "No", and the bass frequencies of the
other channels will be output from the front
speakers. To make the settings, refer to the
instruction manual of the speakers used.
Center 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
Surround 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
"None" can be selected only when "Height 1
Speakers Type" or "Height 2 Speakers Type" is
set to "Not Use".