Filter
Top Products
Advanced Settings
43
Setting Item Default Value Setting Details
InstaPrevue Change the preview display of the video input
through HDMI, which will be displayed using
"InstaPrevue" in the Home menu.
r
Depending on the video source, the preview
thumbnails configured in "InstaPrevue" may
not be displayed properly.
Sub Window Multi Set how to display preview thumbnails.
"Multi": Displays all the thumbnails of HDMI IN
1, 2, 3, 4 and Front at once.
"Single": Displays each thumbnail individually.
Position Bottom/Lower
Right
Set the position to display preview thumbnails.
When "Multi" is selected for "Sub Window":
Select from "Top", "Bottom", "Left" and "Right".
When "Single" is selected for "Sub Window":
Select from "Upper Left", "Upper Right", "Lower
Left" and "Lower Right".
r
If "Monitor Out" is set to "MAIN+SUB" and "Audio TV Out (SUB)" is set to "On"
– Set the audio output of the connected device to "2ch PCM".
– If the audio input is via other than HDMI, sound of the TV connected to the HDMI OUT SUB jack
will not be output.
Auto Standby
Setting Item Default Value Setting Details
Auto Standby On/Off This setting places the unit on standby
automatically after 20 minutes of inactivity
without any video or audio input.
"On": The unit will automatically enter standby
mode ("ASb" will stay lit).
"Off": The unit will not automatically enter
standby mode.
r
"Auto Standby" is appeared on the display
and menu screen 30 seconds before the
Auto Standby comes on.
r
r
Default values vary depending on the
regions.
Setting Item Default Value Setting Details
HDMI Through Off Enable or disable "Auto Standby" while "HDMI
Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
r
"HDMI Through" cannot be set to "On" if
"Auto Standby" is set to "Off".
r
When "HDMI Through" is used, the power consumption increases even when the unit is on standby.
However, the increase in power consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is operating.
Network
Make the network setting.
r
When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value Setting Details
Network Standby Off You can turn on the power of the unit via
network using an application such as Onkyo
Remote.
"On": Use this function
"Off": Do not use this function
r
When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum
by automatically entering the HYBRID
STANDBY mode, where only the essential
circuit is operating.
Wi-Fi Off(Wired) Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
Wi-Fi Setup – You can configure wireless LAN settings by
pressing ENTER when "Start" is displayed.