Filter
Top Products
67
En
09
English
Command mnemonics
Command mnemonics consist of two-digit ASCII
alphabetic coded characters. Uppercase and lowercase
characters can be used without distinction.
Arguments
(1) Arguments are placed in front of the command.
If a command requiring an argument has no
argument, an error is generated.
(2) Arguments are of the following types:
1. Address:
The address consists of ASCII digit characters for the
frame number and time code, according to the
address mode.
The address mode is determined by the FR and TM
commands.
If a value greater than the maximum value is
attributed, the command will not work normally.
2. Argument:
The argument expresses a parameter for commands
with arguments other than the address (KL, GP, DS,
etc.).
The argument consists of ASCII alphabetic coded
characters and digit characters.
Setting the extend
terminal button
functions
“Extend Terminal” refers to the function for controlling
this unit by turning the switch of a device connected to
the EXT TERMINAL connector on the main unit’s rear
panel on and off.
• SW1 to SW8 on the EXT TERMINAL connector on the
main unit’s rear panel are pulled up to +3.3 V. Assign
functions to combinations of SW1 to SW8.
• For the pin layout, see page 64.
• A maximum of 56 switches can be connected by
combining SW1 to SW8.
• For the switch combinations and functions assigned
upon purchase, see page 69.
1 Display the Setup screen.
Press the SETUP button.
2 Select Initial Settings Options Extend
Terminal User.
Use the /// buttons to select, then press the
ENTER button.
Currrent
(1
-
30)
Initial Settings
PLAY
PAUSE
STOP
STEP FWD
STEP REV
SCAN FWD
SCAN REV
NEXT
PREV
DISPLAY
LIST11
LIST12
LIST13
LIST14
LIST15
LIST16
LIST17
LIST18
LIST19
LIST20
LIST01
LIST02
LIST03
LIST04
LIST05
LIST06
LIST07
LIST08
LIST09
LIST10
01.
02.
03.
04.
05. ENTER
06. LIST01
07. LIST02
08. LIST03
09. LIST04
10. LIST05