A SERVICE OF

logo

Open as PDF
next previous
STATus Subsystem
3–144
AM700 Audio Measurement Set Programmer Manual
The following commands can be applied to all SCPI status registers by prefixing the command with
the node(s) that represent the particular register to be controlled.
STATus:OPERation
Table 3–4: Summary of STATus:OPERation
Summary bit settings Condition
0 Calibration
3 Sweep
5 Trigger
12 System
13 Instrument Summary
14 Program Running
Table 3–5: STATus:OPERation
Condition definition Condition number Status
Calibration 100 Set if calibration is occurring
Sweep 103 Set when a sweep is started;
cleared with a sweep is
finished
Trigger for Monitor and FFT 105 Status Bits:
3 Waiting for Mtone Ch 1
4 Waiting for Mtone Ch 2
5 Triggered Ch 1
6 Triggered Ch 2