Getting Started
1–36
AM700 Audio Measurement Set Programmer Manual
SOURce Subsystem Commands.
Commands in the source subsystem control the
signal selections from the AM700 generator. The commands are divided between
those used to control the digital generator and those used to control the analog
generator. SOURce suffixes are used to provide the necessary identification.
Suffixes: SOURce1 is analog generator HR A
SOURce2 is analog generator HR B
SOURce3 is analog generator HB A
SOURce4 is analog generator HB B
SOURce5 is digital generator A
SOURce6 is digital generator B
SOURce7 is DSP A
SOURce8 is DSP B
The generator output for Analog high resolution may be different signals on each
channel. For high bandwidth, both channels output either the same signal or either
output may be set to send silence.
Setting the type of signal output wanted from the generator is done using commands
of the following syntax:
SOURce[1–8]:FUNCtion:SHAPe
[SINusoid|JSINe|TBURst|CIMD|SIMD|
PRNoise|PCHirp|POLarity|TPolarity|MTONe|USER]
where each of the shape parameters is a different signal type available from the
generator.
