Filter
Top Products
33
mode. This mode is strictly north-up.
You can set up Cydle so that it will switch
to Overview mode during navigation when
the next turn is far away. You can specify
this distance and the fi xed zoom level of
Overview in Advanced settings.
An airplane icon indicates Overview mode.
Touch the icon again to return to Track-up
(automatic rotation) mode.
GPS Position Quality (No. 6)
Similarly to the icon found on the GPS Data
screen, the map screens also inform you
about the GPS signal:
• The black satellite dish with the red excla-
mation mark shows there is no connection
with the GPS receiver. GPS navigation is
not possible. Devices with a built-in GPS
receiver are permanently connected, so
this icon may not appear under normal cir-
cumstances.
• Red shows there is a connection, but the
signal is too weak to give a position. GPS
navigation is not possible.
• Black shows there is a GPS position, and
navigation is possible. When only one arc is
shown, the position is 2D (no altitude avail-
able), and position error may be signifi cant,
yet Cydle is ready to navigate.
• A black dish and two arcs represent a 3D
GPS position. Cydle is ready to navigate.
Sound Muting (No. 7)
By tapping this button you can quickly mute
all sounds of the VRVD640G. This will not
modify the volume level and the enabled
or disabled status of the voice guidance or
the key sounds, just mutes the sound out-
put. When muting is enabled, the speaker
icon is crossed out. Touch again to re-en-
able sounds.
NOTE: Sound can be muted in Sound set-
tings also. There you have a Master switch
that works together with the switch de-
scribed above. There is also a Master slider
on that screen. That you can use to fully
turn down the volume of the device. Setting
the volume low is different from muting,
therefore it will not show up on the mute
indicator.
Track Log Recording/Playback Indica-
tor (No. 8)
When a track log is being recorded, a red
icon is displayed on the map screens. This
icon also functions as a button leading to
the Track Log screen where you can stop
the recording or make the track log visible
on the map.
During Track Log playback a green icon
will blink. Touch anywhere on the screen to
stop the simulation.
Cursor (No. 9)
As described earlier, if you touch the map
somewhere or select one specifi c item in
Find, it will become the selected point on
the map, marked with a small red dot and
radiating red circles to make it conspicuous.
You can use this point as starting point, via
point or destination for your route, you can
search for a POI near it, mark it with a pin,
or save it as a POI.
NOTE: When GPS position is available, the
Lock button will appear indicating that you
have disabled Lock-to-Position. Tapping
the Lock button will re-enable the posi-
tion lock and move the cursor back to the
current GPS position. The same happens
when Cydle restores Lock-to-Position
automatically, if it is set in Advanced set-
tings.
Lock To GPS Position And Heading (No. 10)
This semi-transparent icon is displayed
if GPS position is available, and the map
has been moved. It also appears when you
scale or tilt the map while Smart Zoom is
enabled.
This semi-transparent icon is displayed
if GPS position is available, and the map
has been moved or rotated. It also appears
when you scale or tilt the map while Smart
Zoom is enabled.
Normally Cydle positions the map to keep
Navigation System