Filter
Top Products
12 - 18
12. OPTIONS AND AUXILIARY EQUIPMENT
12.1.5 Cables and connectors
(1) Cable make-up
The following cables are used for connection with the servo motor and other models.
The broken line areas in the diagram are not options.
HC-SFS
HC-RFS
HC-UFS 2000r/min
HC-KFS
HC-MFS
HC-UFS 3000r/min
1) 2)
6)
16) 17) 18)
20) 21)
19)
3) 4) 5)
7) 8)
To U, V, W
3) 4) 5)
7) 8)
HA-LFS
Personal compute
r
(Note)
14)
15)
Servo amplifier
CN1A
CN1B
CN2 CN3
Servo amplifier
(Note)
Bus cable
(Note)
Bus cable
Termination connector
13)
(Note)
Connector set
CN1A
CN1B
CN2 CN3
Servo system
controller
CON2
CN4
23)
22)
Note: The bus cable used with the SSCNET depends on the preceding or subsequent controller or servo amplifier connected.
Refer to the following table and choose the bus cable.
MR-J2S- B MR-J2-03B5
QD75M 10) Bus cable :MR-J2HBUS M 12) Connector set:MR-J2CN1
Q172CPU(N) 24) Bus cable :Q172J2BCBL M(-B)
Q173CPU(N) 25) Bus cable :Q173J2B CBL M
Motion
controller
A motion 9) Bus cable :MR-J2HBUS
M-A 11) Connector set:MR-J2CN1-A
MR-J2S- B
MR-J2-03B5
Maintenance junction card
10) Bus cable :MR-J2HBUS M 12) Connector set:MR-J2CN1