Filter
Top Products
User’s Manual xv
3. The standard connecting arrangement (telephone jack type) for this
equipment is jack type(s): USOC RJ11C
The IC registration number of the modem is shown below:
LSI Canada: 4005B-DELPHI
MOTOROLA Canada: 109AH-ML3054
2. The user manual of analog equipment must contain the equipment’s Ringer
Equivalence Number (REN) and an explanation notice similar to the following:
The Ringer Equivalence Number (REN) of the modem, which can vary. For
the REN of your modem, refer to your computer’s user’s manual.
The Ringer Equivalence Number (REN) assigned to each terminal device
provides an indication of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
Notes for Users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid Austel
permit. This modem has been designed to specically congure to ensure
compliance with Austel standards when the country/region selection is set to
Australia. The use of other country/region setting while the modem is attached
to the Australian PSTN would result in you modem being operated in a non-
compliant manner. To verify that the country/region is correctly set, enter the
command ATI9 which displays the currently active setting.
To set the country/region permanently to Australia, enter the following command
sequence:
AT+GCI=09
Failure to set the modem to the Australia country/region setting as shown above
will result in the modem being operated in a non-compliant manner. Consequently,
there would be no permit in force for this equipment and the Telecoms Act 1991
prescribes a penalty of $12,000 for the connection of non-permitted equipment.
Notes for use of this device in New Zealand
n
The grant of a Telepermit for a device in no way indicates Telecom acceptance
of responsibility for the correct operation of that device under all operating
conditions. In particular the higher speeds at which this modem is capable of
operating depend on a specific network implementation which is only one of
many ways of delivering high quality voice telephony to customers. Failure to
operate should not be reported as a fault to Telecom.