Filter
Top Products
User’s Manual 4-21
Operating Basics
Slot-loading optical disc drive
For computer with slot-loading optical drive, to load CD/DVD, please follow the
steps below and refer to gures.
1. Turn your computer on.
2. Gently hold the CD/DVD by the edges with label side facing up, and insert it
into the optical disc drive slot straight on slowly.
n Use only round standard (12 cm) discs with this slot-loading optical drive.
Any other size or shape disc may not be able to be removed from the slot
and may damage the system as well as the disc.
n Gently push the CD/DVD until it is loaded automatically. Do not push
it forcibly or at an angle to the optical disc drive slot. This may cause
damage or adhesion of foreign matter on the surface of the CD/DVD.
These imperfections may prevent the drive from reading from or writing to
it.
Inserting a disc
Removing discs
To remove the disc, follow the steps below and refer to the gure.
Do not press the eject button while the computer is accessing the disc drive.
Wait for the optical media drive indicator to go out before you open the drawer.
Also, if the disc is spinning when you open the drawer, wait for it to stop before
you remove it.
1. To pop the drawer partially open, press the eject button. Gently pull the drawer
out until it is fully opened.
n When the drawer pops open slightly, wait a moment to make sure the disc
has stopped spinning before pulling the drawer fully open.
n Turn off the power before you use the eject hole. If the disc is spinning
when you open the drawer, the disc could y off the spindle and cause
injury.