Filter
Top Products
E-86
SYSTEM UTILITY
■ To check the firmware version
(Firm. Version)
Software that is called “firmware” is built into this unit. This
firmware controls the operation. The following steps describe the
firmware version check procedures.
1. Press MENU while this unit is in the stop mode.
The display changes for the menu item selection.
2. Select “Sys. Utility” by rotating the MULTI JOG knob
(pressing +/– on the remote control).
3. Press the MULTI JOG knob (ENTER on the remote
control) to display “Firm. Version”.
4. Press the MULTI JOG knob (ENTER on the remote
control) again to display the version of the firmware.
The display switches in the order of the system firmware
version ➞ the CDR drive firmware version ➞ type of HDD as
the MULTI JOG knob is rotated (+/– on the remote control is
pressed).
Sys. Utility
L
R
dB –30 –10 –6 –20
Firm. Version
L
R
dB –30 –10 –6 –20
V1.0.00 Jun 2
L
R
dB –30 –10 –6 –20
System firmware version
V1.0.00 Jun 2
L
R
dB –30 –10 –6 –20
CDR drive firmware version
CDRW 1.0D
L
R
dB –30 –10 –6 –20
Type of HDD
ABCDEFGHIJKLM
L
R
dB –30 –10 –6 –20
■ To initialize the setting for each item
(Initialize)
You can initialize the settings that have been changed.
1. Press MENU while this unit is in the stop mode.
The display changes for the menu item selection.
2. Select “Sys. Utility” by rotating the MULTI JOG knob
(pressing +/– on the remote control).
3. Press the MULTI JOG knob (ENTER on the remote
control).
The display changes for the system utility item selection.
4. Select “Initialize” by rotating the MULTI JOG knob
(pressing +/– on the remote control).
5. “Initialize ?” appears on the display if the MULTI JOG
knob (ENTER on the remote control) is pressed.
6. Press COMPLETE.
The display returns to the one when the power of this unit is
turned on.
Initialize
L
R
dB –30 –10 –6 –20
Initialize ?
L
R
dB –30 –10 –6 –20
110_HD1300(E)84-94 02.6.24, 6:52 PM86