Rev. E
Reelmaster 6500-D/6700-DHydraulic System Page 4 - 68
Reel Motor (Barnes)
1
2
3
4
5
6
7
8
Use seal protector tool
TOR4072 when inserting
shaft through seal.
NOTE: Seal protector tool is
part of TOR4070 Cutting Unit
Tool Kit shown in Chapter 7 -
Cutting Units.
Figure 40
1. Retaining Ring
2. Shaft Seal
3. Flange
4. E-Seal
5. O-ring
6. Dowel Pin
7. Valve Block
8. Adjusting Valve
9. Rear Bearing Block
10. Drive Gear
11. Gear Housing
12. Front Bearing Block
13. Idler Gear
4
5
9
10
11
12
13
(54to61N--m)
40 to 45 ft--lb
Removal
1. Park machine on a level s urface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect hydraulic lines. Put caps or plugs on fit-
tings and hoses to prevent contamination. Taghydraulic
lines for proper reassembly.
3. Loosen motor mounting nuts (Fig. 41).
4. Rotate motor c lockwise so motor flanges clear studs
and pull motor out.
Installation
1. Place motor into position on mounting studs. Rotate
motor counterclockwise so motor flanges lock to studs.
2. Tighten motor mounting nuts.
3. Remove caps or plugs from fittings and hoses. Con-
nect hydraulic lines lines to the motor.
2
1
1. Reel motor 2. Motor mounting nut
Figure 41
