Reelmaster 6500-D/6700-DPage 7 - 2Cutting Units
Specifications
Figure 1
REEL CONSTRUCTION: Fairway reels. All welded. 5,
7 or 11 blades.
HEIGHT OF CUT RANGE:
5Blade-1”to1-3/4”(25-44mm)
7Blade-1/2”to1”(13-25mm)
11 Blade -3/8”to3/4”(10-19mm)
Note: Use bedknife Part No. 93-9774 for height-of-
cuts below 1/2”.
REEL DIAMETER: 7 in. (178 mm).
POWER: Reel motors feature quick disconnect for re-
moval or installation onto cutting unit. Cutting units can
be driven from either end.
HEIGHT-OF-CUT & ROLLER ADJUSTMENT: Height-
of-cut adjustment is made at the rear roller w ith quick lo-
cating pin and/or threaded micro-adjustment. Front
roller position is adjustable to set cutting unit attitude.
BEDKNIFE AND BEDBAR ADJUSTMENT: Single
point adjustment mechanism.
ROLLERS:
Front rollers: 3” (76 mm) diameter Wiehle r ollers. Op-
tional 3“ (76 mm) diameter full rollers,Part No.93-3040,
are available for the front position.
Rear rollers: 3” (76 mm) diameter full rollers. All rollers
use the same heavy dutyball bearingswith twoconven-
tionalsingle lip seals and a Torolabyrinth seal to provide
four sealing surfaces to protect the bearings.
ROLLER & SCRAPER KITS:
Rear Roller Brush Kit Model 03875
Wiehle Roller Scraper Part No. 100-9908
Rear Roller Scraper Kit Part No. 100-9920
Shoulder Wiehle Roller Part No. 100-9911
Shoulder Wiehle Scraper Part No. 100-9913
Comb/Scraper Kit Part No. 104-1845
