Electrical
System
Rev. F
Reelmaster 6500-D/6700-D
Page 5 - 41
Electrical System (Rev. C)
Speedometer Sensor Replacement
1. Thread locknut onto speed sensor to allow full expo-
sure of sensor threads.
2. Center a motor piston with the center of the sensor
port (see Sensor Port View in Figure 52 below). NOTE:
Use a suitable tool to feel when a motor piston is in the
center of the sensor port.
3. Lubricate O-ring on sensor.
4. Thread sensor into port until sensor contacts piston.
Motor output shaft must rotate freely 360
o
.
5. Turn sensor out (counter-clockwise) until sensor
orientation grooves are at a right angle + 3
o
to motor
centerline, then back out sensor one full turn or 360
o
.
Hold sensor at this position and tighten locknut to a
torque of 75 - 125 in-lb (8.5 - 14.1 N--m).
1
Figure 51
1. Speedometer sensor
Figure 52
SENSOR SIDE VIEW
Speed Sensor
Lock Nut
Piston
Orientation
Grooves
SENSOR PORT VIEW
Sensor Port
Sensor Port
Piston
POSITION POSITION
INCORRECT
CORRECT
Piston
SENSOR INSTALLATION
Motor
Centerline
Orientation
Grooves
90
o
to 93
o
