Electrical
System
Reelmaster 6500-D/6700-D
Page 5 - 21
Electrical System (Rev. C)
Fuses
The fuse blocks are located under the control panel and
inside the control console.
Identification, Function, and Wiring
The fuses are held in two fuse blocks. Use Figure 20 to
identify each individual fuse and its correct amperage.
Each fuse holder has the following functions and wire
connected to it.
Fuse 1A
A. Supplies power to Primary Electronic Controller
terminals 1L and 1M.
B. Has blue/white w ire (1L), green/black wire (1M)
and red wire (battery).
Fuse 2A
A. Supplies power to ignition switch terminal B.
B. Has red/blue wire (B) and red wire (battery).
Fuse 3A
A. Supplies power to Primary Electronic Controller
terminal 1J.
B. Has pink/black wire (1J) and red wire (battery).
Fuse 4A
A. Supplies power to Primary Electronic Controller
terminal 1K.
B. Has red/black wire (1K) and red wire (battery).
Fuse 1B
A. Suppliespowertoharness spliceSP11thatfeeds
ECU terminal 1A, red diagnostic indicator light,
warning light cluster, and Electronic Controller
communications port and loopback connector.
B. Has two yellow wires.
Fuse 2B
A. Supplies power to harness splice SP9 and SP10
that feeds the hour meter, temperature gauge, fuel
gauge, speedometer, gear tooth s ensor, light switch
(optional), and Turf Defender Leak Detector
(optional).
B. Has two orange wires.
Fuse 3B (When Optional Lighting is Installed)
A. Supplies power to light relay terminal 1.
B. Has two red wires.
1. Fuse block A 2. Fuse block B
Figure 19
2
1
Figure 20
4A
7.5A
10A
10A
10A
20A
AB
1
2
3
4
1
2
3
4
FRONT
RIGHT
10A
15A
Fuse 4B
A. Supplies power to light Secondary Electronic
Controller connector terminal B on RM 6700- D.
B. Has two red wires.
