Reelmaster 6500-D/6700-D
Page 5 - 42
Electrical System (Rev. C)
Installing Optional Lighting (customer supplied)
IMPORTANT: If optional lighting is to be added to
the traction unit, use the following schematic and
part numbers to prevent damage to the traction
unit’s electrical system.
Installation Instructions
1. Install a relay intothe openconnector underthe con-
trol console.
Relay = Toro #70-1480 (Hella #87411 B)
2. Install the light switch.
Switch = Toro #75-1010 (Honeywell # 1TL1-2)
Note: A punch out is provided in the control console
for light switch installation.
3. Crimp a ring or fork terminal onto each of the orange
wires (J24 and J25) under the control console. Secure
them to light switch terminals 2 & 3.
4. Splice power (+) wires from lights to red wire at J23.
5. Secure ground wires from lights to engine ground.
6. Install a 10 amp. fuse in fuse block at location shown
on fuse block decal. D o not exceed fuse rating.
Figure 53
Optional Lighting Circuit (customer supplied)
