Rev. E
Reelmaster 6500-D/6700-DPage 6 - 8Axles, Planetaries and Brakes (Rev. C)
8. Remove capscrews (25) and remove ring gear (18).
9. Remove retaining ring (10) and thrust washer (9).
10.Use a puller to remove spindle (1) from housing (6).
Remove bearing cone (8).
11.Remove and discard all seals.
12.If bearings will be replaced, use a puller to remove
bearing cone (3) from spindle. Remove bearing cups (4
and 7) from housing (6).
Assembly (Fig. 9 & 10)
Note: Use a new seal kit when assembling planetary
wheel drive.
1. Clean parts in solvent. Inspect parts for damage or
excessive wear and replace as necessary.
2. Install lip seal (2a) to spindle (1).
3. Press bearing cups (4 and 7) into housing (6).
4. Press bearing cone (3) onto spindle (1).
5. Installseal(2b) to housing (6). Assemblehousing (6)
to spindle (1). Make sure seals are installed correctly
(Fig. 10).
6. Press bearing cone (8) onto spindle and secure with
thrust washer (9) and retaining ring (10).
7. Install seal (2c), then assemble ring gear (18) to
housing (6) with capscrews (25).
8. Install secondary carrier assembly (11).
9. Install sun gear (21).
10.Install primary carrier assembly (12).
11.Assemble input shaft and sun gears (19, 20 and23).
Install input shaft assembly.
12.Install thrust washer (17) and input spacer (16).
13.Installs eal (2d), then install cover (15). Secure cover
with retaining ring (14).
14.Check operation of planetary wheel drive before
installing on the tractor.
23
2b
12a34 62552c11 18
7
8 9 10 24
22 21 20
12
16
15
19
17
13
14
2d
Figure 10
1. Spindle
2. Seal Kit
3. Bearing Cone
4. Bearing Cup
5. Wheel Stud (8 used)
6. Housing
7. Bearing Cup
8. Bearing Cone
9. Thrust Washer
10. Retaining Ring
11. Secondary Carrier Assembly
12. Primary Carrier Assembly
13. Pipe Plug
14. Retaining Ring
15. Cover Plate
16. Input Spacer
17. Thrust Washer
18. Ring Gear
19. Retaining Ring
20. Sun Gear
21. Sun Gear
22. Thrust Washer
23. Input Shaft
24. Dowel Pin
25. Capscrew
