A SERVICE OF

logo

Open as PDF
next previous
Reelmaster 6500-D/6700-DPage 6 - 10Axles, Planetaries and Brakes (Rev. C)
1
2
3
4
5
6
7
8
9
10
11
12
13
Figure 12
1. Brake Housing - LH
2. Seal
3. Pull Rod
4. Clevis Pin
5. Link
6. Cotter Hair Pin
7. Stationary Disc
8. Rotating Disc
9. Retaining Ring
10. Gasket
11. Actuator
12. Extension Spring
13. Ball
Inspection and Repair (Fig. 12)
1. Scrape gasket material (10) off of brake housing and
planetary wheel drive mounting surfaces.
2. Remove retaining ring (9).
3. Remove stationary discs (7) and rotating discs (8).
4. Remove springs (12).
5. Remove actuator assembly (11, 6, 5, 4, 3).
6. Remove balls (13).
7. Remove balls (13).
8. Wash parts in cleaning solvent.
9. Inspect parts for wear or damage.
10.Reverse steps 2 - 6 to assemble brakes, installing
new parts as necessary. Install a new seal (2).
11.Use a newgasket (10) when installingbrake assem-
bly.