Reelmaster 6500-D/6700-DHydraulic System Page 4 - 80
Lift Cylinders
Removal and Installation
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
2. Disconnect hydraulic hoses from lift cylinder.
3. Remove/install lift cylinders.
Front Center (#1)
A. Remove retaining ring from the cylinder rod end
pin. Remove cylinder pin with remaining retaining
ring and thrust washers fromthe liftarm and cylinder
clevis (Fig. 49).
B. Remove self tapping screw from cylinder pin and
carrierframe. Pull cylinder pinfrom carrier frame and
cylinder clevis (Fig. 49).
C. Install in reverse order. Use a drop of medium
strength thread locking compound to secure the self
tapping screw.
Front Right or Front Left (#4 or 5)
A. Remove retaining ring from the cylinder rod end
pin. Remove cylinder pin with remaining retaining
ring and thrust washers fromthe liftarm and cylinder
clevis (Fig. 50).
B. Remove self tapping screw from cylinder pin and
carrierframe. Pull cylinder pinfrom carrier frame and
cylinder clevis (Fig. 50).
C. Install in reverse order. Use a drop of medium
strength thread locking compound to secure the self
tapping screw.
Rear (#2 or 3)
A. Remove retaining ring from the cylinder rod end
pin. Remove cylinder pin with remaining retaining
ring and thrust washers fromthe liftarm and cylinder
clevis (Fig. 51).
B. Remove retaining ring from the cylinder cap end
pin. Remove cylinder pin with remaining retaining
ring from the frame and cylinder clevis (Fig. 51).
C. Install in reverse order.
1
2
3
4
5
6
7
1. Self Tapping Screw
2. Cylinder Pin
3. Carrier Frame
4. Retaining Ring
5. Cylinder Rod End Pin
6. Thrust Washer
7. Lift Arm
Figure 49
1
2
4
6
5
3
7
Figure 50
1. Self Tapping Screw
2. Cylinder Pin
3. Carrier Frame
4. Retaining Ring
5. Cylinder Rod End Pin
6. Thrust Washer
7. Lift Arm
1
2
5
4
6
3
1. Retaining Ring
2. Thrust Washer
3. Cylinder Rod End Pin
4. Retaining Ring
5. Cylinder Cap End Pin
6. Lift Arm
Figure 51
