Filter
Top Products
Screen Saver panel
The screen saver activates when there is inactivity. Settings include:
Show Screen Saver: — The length of inactivity time (no stream decode, no commands
received, and no user input) before the screen saver starts. Click After to enable the screen
saver mode, then enter or select the number of seconds of inactivity before the screen saver
activates.
Color: — The color of the screen saver. There are three choices:
• Black presents a black screen.
• Blue with OSD bug displays a blue background with the message:
SMD101: No Source Input.
• Custom allows selection of a color using the drop-down pallet.
Mute Video and Sync — When the screen saver is active, sync is still sent to the
connected display. For the display to enter its own power save mode (if equipped), sync
must also stop. Check After and enter the number of seconds of inactivity before sync is
discontinued, up to 500.
Bootplay
Boot play is a feature that allows a source to be defined for automatic playback immediately
after power to the SMD101 is restored or cycled. The boot play source can be a clip, file, or
playlist. Select a source (a stream URL from the network, or a playlist or filename for locally
stored clips) to load on each power up cycle or reboot. Right-click the file and select Set
as Boot Play, or cut and paste the file into the boot play field. Alternately, type the folder
location or stream URL of the desired file directly into the entry field.
Failover
Defines the player response in the event stream data is interrupted. The time to wait after
the stream is lost, the solid background color that plays in the event of stream loss, and an
alternate source clip, image, playlist, or stream on the local drive can be selected.
Display Solid Color — The length of time after a stream loss before a solid color screen
is output to the connected display. Click the After checkbox to activate the failover mode.
Select the time after the stream loss is detected before the solid screen is output.
Color — The color of the failover output. There are three choices:
• Black presents a black screen.
• Blue with OSD bug displays a blue background with the message:
SMD101: No Source Input.
• Custom allows selection of a color from the drop-down list color pallet.
Source from Path Below: — Select a clip or image to display upon entering failover mode.
The clip or image must be on the local storage media. Right-click the file and select Set as
Failover Play or cut and paste the file into the field. Alternately, click Source from Path
Below: and type the folder location of the file into the entry field.
NOTE: Failover images or clips should always be located on local storage. This
provides a more reliable source in the event of network failure or the loss or relocation
of the original source.
SMD101 • Web-based User Interface 33