Filter
Top Products
• MAC Address: — The MAC address of the connected SMD101. The address is also
available on the rear panel label.
• Reset to Default: — Resets all network configuration to default.
• Save — Saves manual network configuration changes.
• Cancel — Discards manual network configuration changes.
NOTES:
• The DHCP assigned Gateway and DNS address are retained after DHCP is
deselected. They are reset using the reset button on the rear panel (see SMD101
Rear Panel Reset on page12) or using the web-based user interface (see
Reset Device on page42).
• The network interface restarts when changes are saved.
Ethernet Diagnostics panel
This panel provides a ping utility for troubleshooting network connection issues.
• Address to ping: — Enter an IP address (10.13.193.168) or a complete host name
(www.extron.com) in this field, then click Ping to start the utility. A dialog box with the
results of the ping opens.
1
92
.16
8
.
3
.5
1
www.ex
t
ron.co
m
Figure 32. Network Ping Dialog
Network Port Mapping panel
This panel provides basic Ethernet configuration that includes:
• SFTP: — Set the port number for SFTP here. Check Enable to use the port.
• SIS (SSH): — SSH provides a method for a SSH client to establish a secure
connection to the player at port 22023, which then supports the SIS command set.
• Telnet (Extron SIS): — The port used by DataViewer or other telnet programs to
access the SMD101. Check Enable to use the port.
• HTTP: — Set the port number for HTTP here. Check Enable to use the port.
• SNMP: — Set the port number for SNMP here. Check Enable to use the port.
• HTTPS/SSL: — Set the port number for HTTPS here. Check Enable to use the port.
NOTE: Changing or disabling this port while using the default port (80) causes a
loss of the connection. Try https://<SMD101 IP> to reconnect to port 443.
• Serial Pass-through: — Set the port number for the serial pass-through feature
here. Check Enable to use the port.
• Reset to Default — Click to return all port mappings to default.
Default port numbers are shown in figure 31 on the previous page. Click the checkbox after
the port number field to enable the port entry in the associated port field. Click Reset to
return the port number to default.
SMD101 • Web-based User Interface 35