Filter
Top Products
NDA-24219 CHAPTER 3
Page 113
Revision 2.0
NAP-200-008
Sheet 9/10
Switch Setting of Circuit Card
(2) Lamp Indications (see Table 008-7)
(3) Switch Settings (see Table 008-8)
The figure in the SWITCH NAME column and the position in in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
Table 008-7 PZ-PW112 (PWR) Card Lamp Indications
LAMP NAME COLOR FUNCTION
MJ Red Lights upon occurrence of a major fault.
MN Yellow Lights upon occurrence of a minor fault.
ON Green Remains lit while the power is on.
Table 008-8 PZ-PW112 (PWR) Card Switch Settings
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
SW For turning AC power and the battery on
OFF
For turning AC power and the battery off
SW102 (Battery Start)
PRESS MO-
MENTARILY
To start each PIM on battery power, when AC
power is not provided
(switch “SW” must be ON)
ON (–)
OFF (O)
ON