Filter
Top Products
CHAPTER 3 NDA-24219
Page 72
Revision 2.0
NAP-200-007
Sheet 23/55
Termination of Cables on MDF
STEP 3:
Set the switch located inside the console according to the type of headset/handset connected. Refer to
Figure 007-16.
Figure 007-16 SN610 ATTCON Switch Setting
• Slide the directory out of the way.
Then insert a flat screw driver’s blade into the notched opening and apply light upward pressure until
the access panel is clear of the front lip. At the same time apply pressure (toward you) at the rear of
the pedestal to move the access panel.
ACCESS PANEL
DIRECTORY