Filter
Top Products
CHAPTER 3 NDA-24219
Page 22
Revision 2.0
1.3 Removing/Inserting Circuit Cards
When removing a circuit card from the PIM or when inserting a circuit card in the PIM, follow the procedure in
Table 3-1.
Table 3-1 Removing/Inserting Circuit Cards Procedure
CIRCUIT CARD
PROCEDURE
CONDITION
INSERT REMOVE
•PN-CP03 (MP)
• PZ-PW86 (PWR)
• PZ-PW112 (PWR)
•PN-PW00
Power off
↓
Insert
↓
Power on
Power off
↓
Remove
↓
Power on
Always insert or remove these circuit cards
with power off to prevent damage to the card
or other system circuitry.
• PN-AP00 (AP00)
• PN-ME00 (EXTMEM)
•PN-BRTA (BRT)
• PN-BS00-B (BS00)
• PN-BS01-B (BS01)
• PN-CK00 (PLO)
• PN-24DTA-A (DTI)
• PN-4RSTB (MFR)
•PN-4RSTC (CIR)
•PN-SC00 (CCH)
•PN-SC01 (DCH)
•PN-SC02 (ICH)
•PN-SC03 (ICH)
•PN-SC03 (CSH)
• PN-VM00
Power off or
MB switch on
↓
Insert
↓
Power on or
MB switch off
Power off or
MB switch on
↓
Remove
↓
Power on
Always insert or remove these circuit cards
under Make Busy condition or power off to
prevent damage to the card or other system
circuitry.
• PN-AP01 (AP01)
• PN-CC00 (ETHER)
Refer to the OAI System Manual.