Filter
Top Products
NDA-24219 CHAPTER 3
Page 119
Revision 2.0
NAP-200-010
Sheet 2/7
System Initialization and
System Data Entry
2. SYSTEM DATA ENTRY
• There are two methods for data entry, both of which employ a Customer Administration Terminal (CAT)
or a Maintenance Administration Terminal (MAT).
2.1 CAT
Any multiline terminal can be assigned as a CAT terminal through programming. The multiline terminal can still be
used as a regular telephone when it is not in CAT mode. If the system is initialized by “C” (Resident System Pro-
gram), every multiline terminal will be able to go into CAT mode. If the system is initialized by “B” (All Clear), only
LEN0000 is assigned as a CAT port (the DLC card must be installed in slot LT00).
The following procedures provide actions to set up a multiline terminal as a CAT.
To set CAT mode:
(1) Press
(2) Press
- CNF lamp flashes.
(3) Press
- CNF lamp is off.
(4) Press
(5) Press
- CNF lamp flashes.
(6) Press
- CNF, SPKR, ANS lamps are lit.
- “CAT MODE” displays on the LCD.
(7) Press
- “COMMAND = -” displays on the LCD.
Note: It is necessary to complete Steps 1 through 6 within 4 seconds.
TRF
CNF
*
TRF
CNF
#
ST