Filter
Top Products
CHAPTER 2 NDA-24219
Page 18
Revision 2.0
4.2 Installation Conditions
(20) The application circuit cards PN-BRTA and PN-24DTA-A cannot be mounted in slots AP1 or AP3 when
an 8-port card is mounted in Slot 04 or 06, since these slots share a connection to the MDF via the back-
plane.
(21) The application circuit card type PN-CC00 can be mounted in any LT/AP slot, but it occupies two slot po-
sitions; i.e. the slot immediately to its right must be vacant.
(22) PN-PW00 can be mounted in any LT/AP slot or LT slot, but it occupies two slots; i.e., the slot immediately
to its left must be vacant.
(23) AD8 (PN-VM00) can be mounted in any LT or LT/AP slot, but it occupies three slots; i.e., the two slots
immediately to its left must be vacant. It is recommended that LT00 be used when mounting the AD8 since
the vacant space to its left is specifically provided for this purpose and only LT00 brings leads out for ter-
mination of the AD8 internal modem.
Note: The PN-CC00 must be mounted adjacent to its related PN-AP01 card, in order to allow the connection of cable type
48-TW-0.3 CONN CA between these cards.