Filter
Top Products
CHAPTER 3 NDA-24219
Page 28
Revision 2.0
NAP-200-002
Sheet 1/2
Marking and Drilling
1. CONFIRMING EQUIPMENT LAYOUT
Install the equipment in an area that provides adequate ventilation and is easily accessible to service personnel.
2. MARKING
Locate and mark the wall mounting points as shown in Figure 002-1.
Figure 002-1 Wall Mounting Points
290 mm
(11.6 inch)
302 mm
(11.9 inch)
30 mm (1.2 inch)
350 mm
(13.8 inch)
PBX BOTTOM POSITION
ANCHOR (x4)
354 mm
(13.9 inch)
PIM
PIM
PIM
354 mm
(13.9 inch)
354 mm
(13.9 inch)
350 mm
(13.8 inch)
302 mm
(11.9 inch)
302 mm
(11.9 inch)
30 mm (1.2 inch)
30 mm (1.2 inch)
30 mm (1.2 inch)
30 mm (1.2 inch)
209 mm
(11.6 inch)
ANCHOR (x4)
ANCHOR (x4)
30 mm (1.2 inch)
ONE PIM CONFIGURATION TWO PIM CONFIGURATION