Filter
Top Products
NDA-24219 CHAPTER 4
Page 129
Revision 2.0
CHAPTER 4 OFFICE DATA PROGRAMMING
1.CUSTOMIZING DATA
1.1 Data Programming Procedure
Table 4-1 shows the procedure and the outline of the work related data programming for the system.
1.2 General Information on Customizing Data
1.2.1 Numbering Plan
This table specifies the service feature access codes, trunk access code, station numbers and other special access
codes. The service feature access codes and trunk access codes are given to each service feature and each trunk
routes, respectively, with a maximum three-digit code. The station numbers are specified by a maximum of four dig-
its.
For the numbering plan of the system the following conditions should be considered.
(1)The same first digit code cannot be assigned to the other features within the Numbering Plan Group pro-
grammed. (This condition is not applicable to the system providing the Single Digit Timing Start Access.)
(2)The feature access codes should be two or three digits because multiple access codes for each feature are
required.
(3)There are four types of station numbering (1 digit – 4 digits), and any combination of these types is avail-
able in one system.
(4)The same station number cannot be assigned, even if the tenant service is applied.
Table 4-1 Data Programming Procedure
STEP WORK REMARKS
1
Obtain the customer’s requirements, and fill in the
Customer Specification Sheets on Section 1.3.
2
Allocate the LC, TRUNK and other interface cards to
the Port Assignment Table on Section
1.2.7
. Make a
Bay Face Layout on Section
1.4.2
for accommodating
cards required in the system.
3
Fill in the data programming sheets on Section 2 with
the Customer Specification Sheet, Port Assignment
Table and Bay Face Layout completed as steps 1 and
2.
For programming method and detailed information on
commands, refer to the Command Manual.
4
Ensure that the data on all programming sheets are
correct and consistent with customer specifications.
5
Specify the switch setting on the boards with the
Switch Setting Table in the Circuit Card Manual.
For the function of each switch on the cards, refer to
the Circuit Card Manual.