Filter
Top Products
NDA-24219 CHAPTER 3
Page 117
Revision 2.0
NAP-200-009
Sheet 3/3
Mounting Circuit Cards
(5) Install the Card Stopper according to the following procedure:
(a) Insert the left side of the Card Stopper to the slot for the Card Stopper as shown in Fig. of
Figure 009-3.
(b) Loosen the attached screw for the Card Stopper, and hang the right side of the Card Stopper onto the
screw. Then, tighten the screw as shown in Fig. of Figure 009-3.
Figure 009-3 Installing Card Stopper
A
B
Fig. A
Fig. B
Fig. BFig. A
CIRCUIT CARD
CARD STOPPER
CARD STOPPER
SCREW
PZ-PW86/PZ-PW112
PIM
SCREW